Planet Networking & Communication IPM-16120 User Manual page 13

Panel Operation
The first mode of LCD is total current, switching with the five-sided button down to show the regular
sequence of current info, max. current, inner temp. and network info as shown below:

When the LCD menu shows current info, hold the five-sided button in the middle for 3 seconds until
a long beep sounds to enter alarm current setting.
1.
For modification of alarm current, press to increase the alarm current by 0.5A in
each press.
2.
After increasing to the maximal alarm current, the value will return back to 0.5A
again, and this will cycle.
3.
Once the alarm current reaches the wanted value, hold the five-sided button in
the middle for 3 seconds until a "beep" sounds to end the setting.

When the LCD shows the maximum total current record, hold the five-sided button in the middle
for 3 seconds until a long beep sounds to adjust it to a zero point.
IP-based 16-port Metered Power Distribution Unit
13
- -
IPM-16120