Tech Lighting ELEMENT E6_LO-C_N Series Installation Instructions Manual page 6

Install the Trim and Lamp
5A
HOOP (INSIDE)
POWER
CONNECTOR
(INSIDE)
2
POWER
PLUG
HOOP
POWER
CONNECTOR
2
POWER
PLUG
NOTE: This section illustrates a square trim.
Round trim pieces install the same way.
Clip the carabiner onto the hoop inside the housing.
1
2 Connect the trim power plug to the connector inside the
housing, on the electrical box side of the housing.
1
CARABINER
HOUSING
OPENING
SAFETY
CABLE
1
CARABINER
SAFETY
CABLE
SAVE THESE INSTRUCTIONS!
5B
REFLECTOR
Line up the trim with the opening, and push the trim
3
completely into the housing. Arrows on the trim and in the
opening indicate the proper orientation.
5C
4
Use 120 Volt 20 Watt Medium Base
Ceramic Metal Halide lamp with housings
E6RLO-C20_ and E6SLO-C20_
Use 120 Volt 39 Watt Medium Base
Ceramic Metal Halide lamp with housings
E6RLO-C39_ and E6SLO-C39_
Use 120 Volt 70 Watt Medium Base
Ceramic Metal Halide lamp with housings
E6RLO-C70_ and E6SLO-C70_
Screw the lamp completely into the socket.
4
6
3
LAMP