Tech Lighting ELEMENT E6_LO-C_N Series Installation Instructions Manual page 2

1C
6
ADJUSTABLE BAR
TRIM HOLDER
HOUSING
TRIM HOLDER
SELF TAPPING SCREW
Adjust the horizontal position of the trim holder by sliding
6
the housing on adjustable bars.
When the desired location is achieved, tighten the two self-
7
tapping screws to lock the housing onto the adjustable
bars.
NOTE:
Notches in trim holder can be used to
align multiple housings using a laser or string.
HOUSING
NOTCH
7
NOTCH
7
Install the Housing with Butterfly
Brackets
2A
SLOT
BEVELED
CORNER
NOTE: Skip to Page 3 if installing the housing
with adjustable bars.
Loosen (Do not remove)
1
Slip the button head screw through the large opening in
2
the housing slot. Make sure the beveled corners of the
butterfly bracket are toward the bottom of the housing.
Slide the butterfly bracket within the slot to the desired
3
height, and tighten the wing nut to secure the bracket.
Repeat steps 1-3 for the other side.
4
5 Use the butterfly brackets to mount the housing, according
to local building codes and electrical codes.
NOTE: Notches in trim holder can be used to
align multiple housings using a laser or string.
2
2
WING NUT
BUTTERFLY
1
BRACKET
the wing nut.