Tech Lighting ELEMENT E6_LO-C_N Series Installation Instructions Manual page 3

Connect Power to the Housing
3A
ELECTRICAL
BOX COVER
1
Push up the tabs on the electrical box and remove the
1
electrical box cover.
3B
CONDUIT
2
Install the conduit to the housing electrical box.
2
Run the power line wires into the housing electrical box.
3
WARNING:
RISK OF FIRE. When using the
housing electrical box for power feed through,
MAX
use 8 - #12 AWG branch circuit wires.
TABS
3
3C
4
5
Connect the white wires to the neutral power line wire
4
with the included lever nut.
Connect the black wire to the hot power line wire with the
5
included lever nut.
Connect the green wire and bare wire to a suitable ground
6
according to local electrical codes.
Replace the electrical box cover. Make sure that the top
7
edge of the cover snaps under the tabs.
NOTE:
Before installing drywall or acoustic
panel, power up and run the Element fixture(s)
for 10 minutes to make sure that all electrical
connections are tight and secure. Refer to page 6
to install the lamp for testing.
3
6