Download Print this page
American Standard Beale 4931300 Installation Instructions
American Standard Beale 4931300 Installation Instructions

American Standard Beale 4931300 Installation Instructions

Manual pull-down kitchen & bar faucets

Advertisement

Quick Links

BEALE
MANUAL PULL-DOWN
KITCHEN & BAR FAUCETS
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
(A) Installation less DECK ESCUTCHEON
• Make certain the SEAL (2) is properly seated in bottom recess of MOUNTING RING (10) and SEAL (12) in top recess of
MOUNTING RING (10). Insert supply HOSES (3), SPRAY HOSE (4) and SHANK (5) through mounting hole and seat SPOUT
BASE onto sink or mounting surface. Do not use putty.
• Insert HOSES (3) through RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8).
• Assemble RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8) onto SHANK (5) from underside
of sink or mounting surface. Hand tighten LOCKNUT (8).
• Use a screwdriver to tighten SCREWS (9) on LOCKNUT (8). Work your way around LOCKNUT (8), tightening the screws
slightly each time until all are snug to ensure even pressure.
(B) Installation with DECK ESCUTCHEON (optional)
• Make certain the SEAL (12) is properly seated in top recess of DECK ESCUTCHEON (1) and SEAL (13) is properly seated
in bottom recess of DECK ESCUTCHEON (1). Do not use putty.
• Screw in two THREAD RODS (14) onto bottom of DECK ESCUTCHEON (1).
• Insert SUPPLY HOSES (3), SPRAY HOSE (4) and SHANK (5) through hole of DECK
ESCUTCHEON (1), and mounting surface.
• Follow mounting instructions above
to secure faucet to mounting surface.
Thread the MOUNTING NUTS (11) to
secure DECK ESCUTCHEON.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2016
INSTALLATION
INSTRUCTIONS
Phillips Screwdriver
A
SPOUT BASE
5
4
7
8
- 1 -
4931300
4931410
Adjustable Wrench
Turn off water at
CAUTION
main supply
12
10
2
3
SINK OR
MOUNTING
SURFACE
6
9
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
B (OPTIONAL)
12
SPOUT BASE
14
5
3
11
4
6
7
8
9
M965685 Rev. 1.0 (4/16)
1
13

Advertisement

loading

Summary of Contents for American Standard Beale 4931300

  • Page 1 4931300 4931410 MANUAL PULL-DOWN KITCHEN & BAR FAUCETS Thank you for selecting American Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M...
  • Page 2 MAKE WATER SUPPLY CONNECTIONS • Turn off hot and cold water supplies before beginning. • Connect FLEXIBLE SUPPLY HOSES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply hose (Red Stripe) to Hot wall supply.
  • Page 3 TEST INSTALLED FAUCET • Turn ON water at main supply. • With HANDLE (1) in “off” position, unthread SPRAY (3) from HOSE (2). • Operate handle back to front, in COLD and HOT positions, to flush water lines thoroughly. • Replace SPRAY (3) onto HOSE (2). REMOVE SERVICE If Faucet Drips, Proceed As Follows:...
  • Page 4 BEALE ™ MANUAL PULL-DOWN KITCHEN & BAR FAUCETS MODEL NUMBER 4931300 4931410 M964451-YYY0A SPRAY WITH HOSE (BAR) M951483-0070A M964450-YYY0A CARTRIDGE SPRAY WITH HOSE M918511-0070A (PULL-DOWN) CARTRIDGE SCREWS M922372-0070A AERATOR KEY (PULL-DOWN) M922383-0070A AERATOR KEY (BAR) M964453-YYY0A HANDLE KIT M964452-YYY0A MOUNTING RING M907315-YYY0A ESCUTCHEON CAP A911897-0070A...

This manual is also suitable for:

Beale 4931410