Advertisement
CONNECTION AND PROCEDURE
1. Toggle the adapter's switch to the OFF position and turn off
the radio.
2. Connect the adapter between the RLN4008 Radio Interface Box
(RIB) and the RKN4074 or RKN4083 Programming/Test Cable
(Figure 2), or between the computer and the RKN4075 or
RKN4081 Programming Cable (Figure 3).
3. Connect the opposite end of the cable to the portable radio's side
connector or to the mobile radio's accessory connector.
NOTE: Programming cables for the mobile radio require
Adapter Cable RLN4853 to make this connection.
4. Toggle the adapter's switch to the A (flashing mode) position and
turn on the radio. The radio is ready for flashing.
NOTE: Some flashing procedures have specific instructions
for using the adapter's switch position B. Refer to the
instructions provided with the upgrade tool that you are using
for such instructions.
2
Advertisement
