Download Print this page

Hollywood Sport Rider HR1000 Quick Start Manual page 4

2 bike rack

Advertisement

14. With the bicycle sitting in the wheel holders, and the large hook in the lowest
possible position on the bike frame, tighten the quick release lever at the base of
the hook, turning the knob until it is snug, then clamping (closing) the quick
release lever to make it absolutely tight. See Fig. 6 showing bikes mounted on the
Sport Rider rack.
15. Use the Velcro wheel straps that are attached to the wheel holders to wrap
around each bike's wheel/tire and strap them down securely as follows:
a. Wrap strap through spokes and around wheel holder.
b. Bring strap up around tire, and through plastic loop.
c. Bring strap down after passing through loop.
d. Attach Velcro firmly. See Fig. 7.
16. Use the security strap as the final component
to secure the bikes to the rack. Thread it through all
the bicycle wheels and frame(s), plug the male part into
the female part, then pull strap end to tighten until snug.
17. Double check before driving off:
A) Hook quick release levers are tight for both bikes.
B) All wheel straps are fastened through wheels and
tires on wheel holders.
C) Security strap is attached, strapping both bikes
securely to the rack.
18. Use the security strap to keep the wheel support tubes together in vertical
position when rack is not is use.
19. Warnings:
 This product is NOT to be used on any trailer, fifth wheel or
vehicle being towed by another vehicle
 Drive slowly on bumpy or dirt roads.
Do not exceed the 45 lb per bike weight capacity
Limited One Year Warranty:
This rack is warranted for a period of one year against defects in materials and workmanship, effective from the date of
purchase to the original purchaser. The manufacturer will repair or replace any defective parts due to materials or
workmanship. The manufacturer of this product shall not extend the warranty to 1) Any failure or malfunction of the product
do to any of or modifications to the product; or 2.) Damages not attributable to a defect in materials or workmanship; or 3.)
Damages resulting from improper installation on vehicle or attachment of bicycles on rack. Consequential or Incidental
Damages: The manufacturer shall not be liable for any consequential or incidental damages in connection with the purchase,
use or handling of this bike rack. Purchaser's Rights: Some states do not allow the exclusion or limitation of consequential
or incidental damages and the above limitation may not apply to you. This warranty gives you specific legal rights and you
have other rights, which vary from state to state.
Hollywood Engineering PO Box 627 Gardena, CA 90248
Phone: 800-747-4085 FAX 310-516-8955
www.hollywoodracks.com

Advertisement

loading