Advertisement
10. Take the shorter (a.) of the two threaded hitch bolts (1-1/2" long) and slide on
first the lock washer (d.), and then the large flat washer (c). When the washers are
installed, install the threaded hitch bolt through the hitch bolt hole in your
receiver, then thread it into
Fitting bikes to the Hollywood Sport Rider:
11. To fit the first bike (closest to the vehicle) more easily, the vertical tube of the
main rack may be tilted down (away from vehicle). To do this, simply loosen the
black knob at the bottom of the main rack (see Fig. 4), then depress the release
lever and fold the vertical tube to a horizontal position. Note: Never fold down
main tube with bike(s) mounted.
Place the first bike in the wheel holders, then rotate the vertical tube up. When
it reaches the top, it will "snap" into place. At this point, it is important to
re-tighten the black knob securely.
See Fig. 4.
12. Always position the smaller bike
between the bicycle support (vertical
tube of main rack, 1.) and the car
bumper, using the larger hook. For
bicycles with a slanted top tube (i.e.
ladies bikes and some mountain
bikes), position hook at the lowest
point of the top tube, as far down a
possible.
13. When you have found the correct
position for the bicycle frame, adjust
Fig. 7
the insert tube of your rack. Tighten securely.
the wheel holders such that they are
directly beneath each wheel. To
adjust the wheel holders, loosen the
knobs and slide along the wheel
holder support tube. Tighten knobs
securely. For more permanent wheel
holder position, remove knobs and
install (j) nuts and nut covers. An
adjustable wrench, ½" or 13 mm
wrench or socket required. Be sure
to tighten nuts securely.
Fig. 6
Advertisement
