Hollywood Sport Rider HR1000 Quick Start Manual

Hollywood Sport Rider 2 Bike Rack
Not to be used on any trailer, fifth wheel or vehicle being towed by another vehicle.
Weight Limit 45 lbs. per bike Fits both 1 ¼" and 2" hitch receivers Model No. HR1000
When you open your Hollywood Sport Rider 2 box, you should have the following:
1. Main rack with wheel holders and wheel holder support tubes.
(Velcro straps are attached to the wheel holders, but are NOT shown in images)
2. Insert tube for 2" receiver (remove black "U" spacer for use on 1-1/4" receiver).
3. Short hook assembly.
4. Long hook assembly.
5. Hardware bag with the following:
a. Hitch bolt for 1-1/4" receiver (1-1/2")
b. Hitch bolt for 2" receiver (2-1/4" long)
c. Washer for hitch pin (1" dia.)
d. Lock Washer for hitch bolt (3/4" dia).
e. 2 bolts to attach insert tube (2-1/4")
f. 2 nyloc nuts for attachment bolts (1/2")
g. 6 black plastic nut caps (5/16")
h. 2 black plastic nut caps (1/4")
i. 1 security strap with 2 part side release buckle
j. 4 each 5/16-18 nuts for alternative wheel holder fastening
1. The wheel holder tubes are hinged onto the main rack frame (1.). Fold down the wheel
support tubes away from the main rack, to a horizontal position. See Fig. 1.
2. Install the long hook (4.) on the main vertical tube and position towards the rear of the
rack (Fig. 2.). The hook's exact position on the tube is not important at this time.
3. Place the security strap (i.) next on the same vertical tube, the small end loop over the tube
(the small loop end has the female part of the buckle sewn to it). Use this strap to keep
wheel support tubes together while not in use - see fig. 1
Fig 1.
4. Install the short hook (3.) on the vertical tube,
facing the opposite direction from the large hook.
See Fig. 2.
5. Loosen adjustment knob and fold the vertical
tube on the main rack down to a horizontal position.
See how to use the knob in Fig. 4.
6. Fit end of the insert tube (2.) with the two small
holes to the main rack and attach with 2 bolts (e.)
and nyloc nuts (f.) using a ½" or adjustable wrench.
Tighten securely. See Fig. 3.