Shutting Down And Removing A Fpm-7620E Module From A Chassis - Fortinet FortiGate-7000E Series Manual

Hardware installation
7. Push down both power sliders to make sure the module power switch is on.
When the module is fully in position, the power sliders should drop down, lock the levers, and turn module power on.
Gently push both power sliders down to their bottom position to make sure they are fully closed.
Power slider
down to bottom
8. If the chassis is powered on, check the modle LEDs to verify that the module is
operating correctly
LED
Status
Alarm
HA
Power

Shutting down and removing a FPM-7620E module from a chassis

This procedure describes how to shut down and remove a FPM-7620E module from FortiGate-7000 chassis. The
procedure includes photographs to illustrate the procedure steps. The photos were taken in one of Fortinet's hardware
labs using a generic module and FortiGate-7000 chassis.
FPM-7620Es are hot swappable. This procedure is the same whether or not the chassis is powered on.
FPM-7620E Processing Module Guide
Levers locked
Normal operation state
Green
Off
Off
Green
Power slider
down to bottom
Fortinet Technologies Inc.
15