Hardware Installation; Fpm-7620E Mounting Hardware - Fortinet FortiGate-7000E Series Manual

Hardware installation

This chapter describes installing a FPM-7620E processing module into a FortiGate-7000 chassis.

FPM-7620E mounting hardware

To install a FPM-7620E you slide the module into slot 3 or up in the front of an FortiGate-7000 series chassis and then
use the mounting hardware, described in
locked into place and positioned correctly, the module front panel is flush with the chassis front panel and connected to
the chassis backplane.
To position the module correctly, you must use the mounting hardware shown below for the right of the FPM-7620E
front panel. The mounting hardware on the left of the front panel is the same but reversed. The FPM-7620E mounting
hardware aligns the module in the chassis slot and is used to insert and eject the module from the slot.
Power Slider
Module lever
(to open move the power slider up about 2 mm)
The FPM-7620E module levers align the module in the chassis slot and insert and eject the module from the slot. The
power sliders activate micro switches that turn on or turn off power to the module. When both power sliders are raised,
the module cannot receive power. When the sliders are fully closed, the module can receive power if it is fully inserted
into a chassis slot.
FPM-7620E Processing Module Guide
Mounting hardware on page
Alignment Pin
Secure Screw
Open
5, to lock the module into place in the slot. When
Module Lever
Power Slider
Secure Screw
Closed
Alignment Pin
Fortinet Technologies Inc.