Safety 1st Go Hybrid Booster Manual page 25

4358-4856 Go Booster 8/31/09
F-1 Preparing Belt-Positioning Booster
40-100 lbs (18.1-45.4 kg) and 43-57 in. (110.1-144.8 cm) and
Over 1 Year Old. Belt-positioning booster using only vehicle
lap/shoulder belt.
Lap/Shoulder Belt
Use only the vehicle's lap and shoulder belt system
when restraining the child in this belt-positioning
booster seat.
Do not use the LATCH belts when using as a belt-
positioning booster. Store the LATCH belts.
Do not use the harness system or top anchorage
strap (tether) when using as a belt-positioning
booster.
Failure to follow these warnings can result in
serious injury or death.
12:02 PM Page 49
You MUST remove the harness
system to use this seat as a
belt-positioning booster.
47
F-2 Installing Using the Lap and
Shoulder Belts
Store the LATCH Belts in the storage location.
1.
2.
3.
thighs. The shoulder belt should lay snugly across the center of the
child's shoulders and across the chest (not on the face or neck).
Pull up on the shoulder belt to tighten.
48
Place Belt-Positioning
Booster seat forward-
facing in vehicle
Center the booster seat in the
chosen seating position. The
back of the booster seat
should be flat against the
vehicle seat back.
Place Child in Seat
Child should sit with its back flat
against the vehicle seat and
bottom flat against the seat
base.
Buckle Lap and Shoulder
Belt
Route lap portion of the
lap/shoulder belt under both
armrest. The shoulder belt
should go under the armrest on
the vehicle buckle side only.
Lap belt should cross the child's
continued on next page.