Advertisement
INSTALLATION INSTRUCTIONS
Rough-in the water supply lines and the drain piping.
‰
Install a minimum of a 2x6 as a wall brace to provide support for
‰
the wall bracket. The brace should be the same length as the
console table, 26" and should be positioned 35-3/4" from the
finished floor to the top edge of the board. The center of the wall
brace should be in-line with the drain outlet.
Finish the wall.
‰
Mark the centerline on the floor and the wall.
‰
Mark the location of the holes on the floor for the feet anchors.
‰
Drill a hole 1/4" D. x 1/2" deep, in the finished floor for each foot
‰
anchor. The holes should be 21-3/8" from the wall and 12-27/32"
from the centerline.
Check that the socket head screws on the towel bar
‰
mounting assemblies are tight on both leg assemblies.
Assemble the two towel bars to one leg assembly using two
‰
setscrews.
Assemble the second leg assembly to the open end of the
‰
towel bars with the remaining two setscrews.
1110776_2_A
3 of 6
1.
PRePARe THe SITe
2.
ASSeMBLe THe FRONT CONSOLe TABLe LeGS
One™ Console Table
Wall Bracing
(2x6 minimum)
Finished
Floor
21-3/8"
(54.3 cm)
12-27/32"
(32.6 cm)
Towel Bar
Verify socket head
screws are hand tight,
tighten if necessary
Table Leg
Assembly
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Finished
Wall
35-3/4"
(90.8 cm)
C L
Mark the
anchor
holes.
Foot
Anchor
C L
Holes
Set Screws
Advertisement
