Kallista One P23080 Installation Instructions

INSTALLATION INSTRUCTIONS
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before
you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
Observe all local plumbing and building codes.
Shut off the main water supply.
Carefully inspect waste and supply tubing for any sign of damage.
Replace waste or supply tubing if necessary.
Do not use petroleum based products in this project; the only exception being the sealant; between the wall
and the back flange.
Kallista reserves the right to make revisions in the design of faucets without notice, as specified within the
Price Book.
Hex Adjustable
Wrench
Wrench
IMPORTANT! The supply should not extend farther than 1/2" (1.3 cm)
beyond the finished wall material.
Determine the faucet installation location.
Install a supply stop and route the water supply to the installation
location.
Install appropriate backing and secure the supply pipes so the
front face of the pipe nipple will protrude no more than 1/2" (1.3 cm)
beyond the finished wall surface.
Install the wall board and finished wall material. Allow a 1-3/16" (3
cm) diameter opening in the wall board and finished wall material for
the faucet supply connection.
1072018-2-B
Page 1 of 3
THANK YOU FOR CHOOSING KALLISTA

BEFORE YOU BEGIN

TOOLS AND MATERIALS

Silicone
Thread
Sealant
Sealant

1. PREPARE THE SITE

One™ Wall Mount Pot Filler
Strap
Wrench
1/2" (1.3 cm)
Max
1/2" NPT
Male Pipe Thread
1-3/16"
(3 cm)
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
P23080
Level
Supply
Tile