Sealey SSC11003 Instructions Manual page 2

1.2. SAFETY (INSTALLATION).
DO NOT usE tHE comPrEssor If It Is fAuLtY. Ensure
7
that the compressor is in good condition before use.
If the compressor is noisy or vibrates excessively when
running, stop it immediately. If in any doubt do not use the unit
and contact an electrician/service agent.
oPErAtE tHE comPrEssor At tHE rAtED VoLtAGE.
3
operate the compressor at the voltage specified on the
electric data plate. You could damage or burn-out the motor
and other electric components if the compressor is operated at
a higher or lower voltage than its rated voltage.
usE tHE comPrEssor corrEctLY. operate the
3
compressor in compliance with the instructions provided in this
manual. DO NOT allow children or those who are not familiar
with it to use the compressor.
1.3. SAFETY (OPERATIONAL AREA/ENVIRONMENTAL).
oPErAtIonAL ArEA. Keep the work area clean and remove
3
any tools or unnecessary items that are not required. Install
the compressor on a firm surface away from any heat sources.
usE tHE comPrEssor In A WELL VEntILAtED ArEA.
3
Ensure there is adequate ventilation space all around the
compressor.
DO NOT usE tHE comPrEssor In tHE PrEsEncE of
7
fLAmmABLE LIquIDs or GAs. the compressor may
produce sparks while running. DO NOT use the compressor
where there may be paints, petrol (gasoline), chemical
compounds, glues or any other flammable or explosive
material.
KEEP unAutHorIsED PErsons AWAY from tHE
3
WorKInG ArEA. All non-essential persons must be kept at a
safe distance from the operational area. Prevent children or
anyone else from touching the power supply cable of the
compressor.
DO NOT use the compressor outdoors. DO NOT
7
install the compressor in damp or wet locations or in areas
where condensation may form.
DO NOT cover the compressor or restrict air flow around the
7
machine whilst operating.
If tHE comPrEssor Is usED for PAIntInG JoBs.
3
a) DO NOT work in closed rooms or near naked flames.
b) check that the area selected for spraying is provided with
an air change system or adequate ventilation.
c) Wear face and nose mask.
When the compressor is not in use, it should be switched
3
off, isolated from the mains supply and the air drained
from the tank.
storE tHE comPrEssor APProPrIAtELY. If the
3
compressor is not used immediately, it must be stored in a dry
place away from atmospheric agents until it is installed.
1.4. SAFETY (AIR/PRESSURE).
WARNING! THE AIR TANk IS A PRESSuRE vESSEl ANd

THE fOllOWINg SAfETY MEASuRES APPlY:
dO NOT tamper with the safety valve and dO NOT modify
7
or alter the tank in any way. dO NOT strap anything to the
tank.
dO NOT subject the tank to impact, vibration or to heat
7
and dO NOT allow contact with abrasives or corrosives.
DO NOT drill, weld or deform the compressed air tank.
7
DO NOT unscrEW tHE outLEt connEctIon WHEn
7
tHE tAnK Is PrEssurIsED. DO NOT unscrew the
connection for any reason whatsoever without first checking if
the tank is discharged.
Ensure the air supply valve is turned off before disconnecting
3
the air supply hose.
PNEUMATIC CIRCUIT.
use recommended pneumatic hoses. read the instructions
regarding any accessory used with the compressor. Ensure
the safe working pressure of any air appliance used exceeds
the compressor maximum pressure.
Ensure the air hose is not tangled, twisted or pinched.
3
DO NOT operate the compressor without an inlet air filter.
7
© Jack sealey Limited
1.5. SAFETY (TRAINING/GOOD PRACTICE).
DO NOT allow anyone to operate the compressor unless they
7
have received full instructions and adequate training.
KEEP tHEsE usE AnD mAIntEnAncE InstructIons
3
for future reference and make them available to the
compressor
with all the controls and
before starting to work with the
AVoID AccIDEntAL stArt-uP. Ensure that the main switch
3
is turned off before connecting the compressor to the
electrical power supply. never move the compressor while it is
connected to the electrical power supply or when the tank is
pressurised.
PrEcAutIons for tHE PoWEr suPPLY cABLE. DO NOT
3
disconnect the power supply plug by pulling on the cable. Keep
the cable away from heat, oil and sharp edges. DO NOT stand
on the electrical cable or trap it under heavy weights.
LooK AftEr tHE comPrEssor WItH cArE. follow the
3
maintenance instructions. Inspect the power supply cable on a
regular basis and if damaged it must be repaired or replaced
by an authorised service centre. check the outside
appearance of the compressor, ensuring that all is in order.
contact your nearest sealey dealer if necessary.
cHEcK for fAuLtY PArts or AIr LEAKs. Before each
3
use, visually inspect the compressor. If a safety guard or other
part is damaged, they must be checked carefully to evaluate
whether they continue to provide the intended protection.
check the alignment of moving parts, hoses, gauges,
pressure reducers, pneumatic connections and every other part
that may be crucial for the normal operational efficiency of the
compressor. All damaged parts must be properly repaired or
replaced by an authorised service centre or replaced following
the instructions provided in instruction manual.
turn tHE comPrEssor off WHEn It Is not In usE.
3
When the compressor is not in use turn the main on/off
switch to the off position ("0").
DO NOT DEfAcE tHE cErtIfIcAtIon PLAtE AttAcHED
7
to tHE EnD of tHE comPrEssor tAnK.
1.6. SAFETY (PERSONAL/MECHANICAL).
DO NOT usE tHE comPrEssor WItHout tHE sAfEtY
7
GuArDs fIttED. never use the compressor without all the
safety guards properly fitted in their correct place. If these parts
are to be removed for maintenance or servicing purposes,
ensure that they are correctly reinstalled before using the
compressor again.
DO NOT Put oBJEcts or PArts of tHE BoDY Into
7
tHE ProtEctIon GrILLs. never put your hands, fingers or
other parts of the body near moving parts of the compressor.
to do so may cause physical injuries and damage to the
compressor.
DO NOT toucH Hot PArts of tHE comPrEssor.
7
to avoid burns do not touch the compressor cylinder, cylinder
head, motor or pipe from head to tank as these may be hot and
will remain so for some time after shutdown.
ALWAYs WEAr sAfEtY GoGGLEs or equivalent means of
3
eye protection. never direct compressed air towards any part
of your body or that of others.
WEAr APProPrIAtE cLotHInG. DO NOT wear unsuitable
3
clothing, ties or jewellery as these may get caught up in moving
parts. tie back long hair or wear a cap to cover your hair if
necessary.
ProtEct YoursELf AGAInst ELEctrIc sHocKs. Avoid
3
accidentally touching the metal parts of the compressor with
your body, such as pipes, the tank or metal parts connected to
earth. never use the compressor where there is water or in
damp rooms.
Original Language Version
operator. the operator must be familiar
compressor characteristics
machine.
ssc11003 Issue: 1 - 03/05/13