Bose ControlSpace ESP-88 Installation page 2

5. Attach the free end of the GPIO ribbon wire to the available connector located beside the first GPIO card connector on the motherboard.
See Figure 3.
6. Reattach the top cover and fasten the 8 screws. Plug in the power supply and turn on the ESP-88.
7. Use the ControlSpace™ designer software to verify the card was inserted correctly:
a) Press scan and confirm that the software detects the card.
b) If the card was installed correctly, right-clicking the ESP-88 and displaying its properties will show that GPIO usage is in slot 1 and slot 2.
See Figure 4.
8. If an error message appears, or the software does not properly detect the GPIO card, repeat the installation instructions. Be sure that the
ribbon wire is completely pushed into both connectors.
Figure 3
For installation instructions in other languages, please visit pro.bose.com.
Figure 4
©2006 Bose Corporation, The Mountain Framingham,
MA 01701-9168 USA
AM299788 Rev.00
pro.bose.com