Cooper Lighting Corelite Jaylum Suspended T5 Installation Manual page 2

MOUNT SPACING
FIXTURE LENGTH
Power
SAMPLE ROW
FIXTURE LENGTH
*For continuous rows see joining sheet.
JOINING
Install rst xture with two AC cable
assemblies, then second xture with
one additional cable.
END CAP
Slide-N-Lock
TM
TAB
NOTE: Remove lm from optic before installing.
To Install - set in place over lamps.
The Slide-N-Lock comes pre-set from the factory to the customer speci ed optical setting.
TM
To eld adjust the optic, depress the control notch and slide tab to desired setting (instructions
located on optic).
Not all options available. Please consult your Cooper Lighting Representative for availability. Speci cations and Dimensions subject to change without notice.
96" SPACING 96" SPACING
Bend out tapered aligning tabs and
t into aligner slots. (Fixture 2 is now
supported by xture 1 at the joint.)
Make electrical connections.
End Caps: Slide into end of xture
and secure with two 10-32 x 3/8"
self tapping screws.
*For continuous rows see joining sheet.
JAYLUM
Suspended T5/T8 Luminaire
POWER DROPS / KNOCK-OUTS
Break o appropriate KO, slide power cord through KO opening, then
secure power cord with strain relief.
Note: Location of the KO's varies depending on xture
Tuck wires into wire cavity, slide both
xtures together. Secure xtures using
two 10-32 x 3/8" screws and nuts.
Tighten 1/4 turn past hand-tight.
INSTALL LAMPS
*T5 Shown
DUST COVER
Set in place.
INSTALLATION
5/8"-7/8" KNOCK OUT
ADE130026