Epson SC-S60600 Series Operator's Manual page 21

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
A
Press the M button, select Feed To Cut Position,
and then press the Z button.
The trailing edge of the print is fed to the cut
position (cutter groove).
If you have printed the amount of media
remaining, press the u button to rewind the
media so that this information will remain on the
unprinted roll after the media is cut.
B
When using the Auto Take-up Reel Unit, raise
the tension bar.
Basic Operations
C
Hold the cutter vertically, and then move it so
that the cutter blade fits closely to the side surface
of the cutter groove.
When work cannot be performed properly, such
as when your hand hits the front cover, open the
front cover, and then cut.
c
Important:
When cutting the media, make sure the media
has not risen up inside the front cover or come
free from the media edge plate before
proceeding to the next print.
D
Set the Auto switch to Off. Take up the cut media
completely by operating the Manual switch
according to how the media is rolled.
21