Rainbow Turbo Carnival Clubhouse Assembly Instructions Manual page 49

Step 9
*NOTE: Depending on your set configuration, the Accessory Arm (6134) may need to be cut
down. Refer to Inset A for modification instructions.
1. Measure up 85 5/8" and attach 6 Hole Facia (4051) to Corner Uprights (6129) using 3/8" Hardware
(H3) (H116). Be sure that Facia is flush with outside faces of Uprights and oriented as shown with
offset holes up.
*NOTE: Top of 6 Hole Facia (4051) will be flush with top of 4 Hole Facia (4050) when properly
installed.
2. Position Accessory Arm (6134) against Corner Uprights (6129), lining up holes in Accessory Arm with
previously drilled holes in Uprights. Attach Accessory Arm using 3/4" Hardware (H5) and 1/2"
Hardware (H4) (H12) (H18) (H29) (H71).
3. Position Right Slim Bracket (6107) up against Accessory Arm (6134) and Corner Upright (6129) and
attach using 3/8" Hardware (H3) (H116).
*NOTE: Adjoining faces of Slim Bracket, Accessory Arm and Corner Upright should have no
gaps when properly installed.
6134
H116
OFFSET
HOLES
UP
Lower Level Wall
INSET A
ROUTER AND
STAIN CUT END
H3
4050
6129
85 5/8"
Assembly
36"
6129
4051
6107
6129
48
CUT OFF
THIS END
H71
H5
6134
H4
H12
H3
H116 6129
H29
H18