Advertisement
4. CONTENTS
4.1.
Assembly
4.1.1. The major structural components including the hydraulic ram are pre-assembled, requiring only attachments. use the
picture below to check all parts are present.
4.1.2. A separate twin wheeled carriage enables transporting the lowered assembled vehicle lift. This carriage is also used for
removing compression springs from the base frame sprung loaded castors. Refer to section 5.8.2 and 5.8.3.
4.1.3. See the 'Maintenance' section for air line and hydraulic line circuit connections.
Site pump here
fig.4
Jacking point for castor
compression spring removal
© Jack Sealey Limited
Pawl disengage rail
Sprung loaded transit castor
and spring retainer cup
Original Language Version
Front transit point twin wheel carriage
"H" = 500
"H" = 1000
Assembly shown full height
Ensure the pin enters
a graduated pin hole
in the quadrant plate
Support pad swivel
(fixed longitudinally)
AVR2500A
Issue: 1 - 07/11/14
Advertisement
