Rheem 801T Series Installation Instructions Manual page 12

DUCTING
FIGURE 5
LIFT UP, PULL OUT
1. REMOVE 2 SCREWS, LIFT BASE UP, SLIDE FORWARD TO REMOVE.
2. INSTALLATION IS REVERSE OF REMOVAL.
** VERIFY REAR FLANGE IS SEALED PROPERLY AS SHOWN IN DETAIL.
FIGURE 6
12
NOTE:
NOTE:
SOLID BASE PLATE PROVIDED WITH 80%
SOLID BASE PLATE PROVIDED WITH (-)801P
SINGLE STAGE CONSTANT TORQUE
MODELS ONLY.
MODELS ONLY .
WHEN SOLID BASE PLATE IS USED . TAPE
WHEN SOLID BASE PLATE IS USED, TAPE AROUND BOTTOM FLANGES OF CABINET
AROUND BOTTOM FLANGES OF CABINET BE- BEFORE THE UNIT IS INSTALLED.
FORE THE UNIT IS INSTALLED .
CUT OUT USING
EMBOSSED ANGLES
AS A GUIDE
FOR PROPER SIZE
23" X 14"
ST-A1220-08
SOLID BASE FLANGE
FITS UNDER
CABINET BOTTOM
ST-A1220-10
ST-A1220-10-X0
FIGURE 7
ST-A1194-08-X0
A
I
R
F
L
O
W
CUT OUT USING
EMBOSSED ANGLES
AS A GUIDE
FOR PROPER SIZE
23" X 14"
ST-A1220-11-X0
ST-A1220-11