Steps To Drive Robstep M2; Startup Of Transporter Body - Robstep M2 User Manual

6. Steps to Drive Robstep M2
You should pay attention to related safety notes during using
driving, and it is very important to understand these safety notes before using.
◆ Before using, please make sure
specific parts and charge of the battery, please see this manual.
◆ Before driving, you should fully know the driving environment.
◆ Please wear a safety helmet and protective clothing before driving Robstep M2.
◆ Please do not wear sharp objects to avoid injury during driving.
◆ Robstep M2 is a traveling tool for one person, and only one person can stand on the transporter body during using.
◆ When you practice driving, please do it on a spacious and flat indoor or outdoor site with the area of at least
please make sure the site is safe and spacious, the ground is flat, and no car, pedestrian, pet, bicycle or other obstacle inte rfere the practice.
◆ Please do not practice driving on wet and slippery ground.

6.1 Startup of Transporter Body

Description of startup steps
When you start Robstep M2
long time, please turn on the system power (for normal startup,
please ignore this step)
Robstep M2 is assembled, and charge the battery continuously for more than 4 hours. For installation of
Power Button
for the first time or did not use it for a
Robstep M2. Thus, you must fully understand all notes in this manual before
Then, use the remote controller to control accordingly (for
detailed functions, please refer to Chapter 3 Information
about Remoter Controller for Robstep M2)
17
5m*5m . At the same time ,
Power-off
Key
Mute Key
Startup Key Startup Key
Normal Beginner
Mode
Mode