Basic Operating Instructions - Tivic Health ClearUP User Manual

Basic Operating Instructions

Step 1
Turn Unit on.
Press Power Button for ON. Press
and hold for OFF. (Unit will run a
self-test. The Contact Indicator Light
flashes.The Treatment Intensity
Level Lights flash).
Step 2 Hold device with thumb and forefingers and
put metal tip in contact with your skin.
1
START
Glide tip VERY SLOWLY to
locate the first treatment
point. Tip: Do not press
button during treatment.
Step 3
Repeat gliding and holding while unit vibrates.
Treat along the cheek, nose and under brow bone.
(See the "C" shaped path in photo on the right.)
Treat both sides of the face. Complete a cycle and
then concentrate on areas of pain.
Treat for 5 minutes total time.
Exact treatment points may vary.
14
POWER
BUTTON
STOP
HOLD TIP ON TREATMENT
POINT until vibration stops.
Unit vibrates when it finds a
treatment point.
If unit doesn't
vibrate, see Trouble Shooting tips.
Treatment Intensity Levels
LOW: 1 Light MEDIUM: 2 Lights
Press Power Button briefly to change levels.
The higher the level the stronger the power. Unit
defaults to LOW. Start your first treatment in LOW.
Adjust according to your comfort.
Warning! Do not use device if the Treatment Level Lights continually
flash. This indicates a fault in the device. Contact Customer Service.
2 1
Glide very slowly to locate
the next treatment point.
Tip: Do not press button
during treatment.
HIGH: 3 Lights
STOP
Unit VIBRATES when it
finds a treatment point.
Hold tip on treatment
point, until the vibration
stops, about 7 seconds.
.
15