Electromagnetic Emissions - Tivic Health ClearUP User Manual

Electromagnetic Compatibility
(EMC) Information
Guidance and manufacturer's declaration-

Electromagnetic emissions

The ClearUP™ is intended for use in the electromagnetic
environment specified below. The customer or the user of the
ClearUP™ should assure that it is used in such an environment.
Emissions
Compliance
test
RF emissions Group 1
CISPR 11
RF emissions Class B
CISPR 11
Harmonic Compliant
emissions
IEC 61000-3-2
Voltage Compliant
fluctuations /
flicker emissions
IEC 61000-3-3
22
Electromagnetic
environment -
guidance
RF emissions are low
compared to the FCC
Group 1 limits.
RF emissions are low
compared to the FCC
Class B limits.
Electromagnetic Compatibility
(EMC) Information
Guidance and manufacturer's declaration-
Electromagnetic immunity
The ClearUP™ is intended for use in the electromagnetic
environment specified below. The customer or the user of the
ClearUP™ should assure that it is used in such an environment.
Immunity Compliance Compliance
test level
Electrostatic +/- 6 kV
discharge contact
(ESD) IEC +/-8 kV air +/-8 kV air
61000 - 4-2
Electrical +/-2 kV for +/-2 kV for
power supply power supply
fast
lines +/-1kV lines +/-1kV
transient/
for input/ for input/
burst IEC
output lines output lines
61000-4-4
Surge IEC +/-1 kV +/-1 kV
differential differential
61000-4-5
mode +/-2kV mode +/-2kV
common common
mode mode
Voltage dips. <5% Ut (>95% <5% Ut (>95%
dip in Ut) for dip in Ut) for
Short
0.5 cycle 0.5 cycle
Interruptions
and voltage
40% Ut (60% 40% Ut (60%
variations
dip in Ut) for 5 dip in Ut) for 5
on power
cycles cycles
supply input
70% Ut (30% 70% Ut (30%
lines IEC
dip in Ut) for 25 dip in Ut) for 25
61000-4-1
cycles cycles
<5% Ut (>95% <5% Ut (>95%
dip in Ut) for dip in Ut) for
5 sec 5 sec
Power
frequency
(50/60 Hz)
30 A/m
magnetic
field IEC
61000-4-8
Conducted 3 Vrms
RF IEC 150kHz to 80 150kHz to 80
MHz
61000-4-6
Radiated RF 3 V/m 80MHz 3 V/m 80MHz
IEC 61000-
to 2.5GHz to 2.5GHz
4-3
Electromagnetic
level environment -
guidance
+/- 6 kV Did not show
contact sensitivity to test
levels.
Did not show
sensitivity to test
levels.
Did not show
sensitivity to test
levels.
AC use only in
charging mode.
Device did not show
30 A/m sensitivity to the test
levels.
3 Vrms Separation distances
do not apply,
MHz
because there is no
RF emitter in the
device. Device uses
haptic technology to
generate the vibration.
23