Cisco SCE8000 Removal And Replacement Procedures page 21

Hide thumbs Also See for SCE8000:

Chapter 9 Removal and Replacement Procedures

At the SCE# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000

Step 1

platform before installing or removing any module.

Verify that the captive installation screws on all of the modules in the chassis are tight. This step assures

Step 2

that the space created by the removed module is maintained.

If the captive installation screws are loose, the EMI gaskets on the installed modules will push the

Note

modules toward the open slot, reducing the opening size and making it difficult to install the replacement

module.

Disconnect all cables.

Step 3

Step 4

Loosen the two captive screws on the module.

Step 5

Place your thumbs on the left and right ejector levers and simultaneously rotate the levers outward to

unseat the module from the backplane connector.

Grasp the front edge of the module and slide the module part of the way out of the slot.

Step 6

Step 7

Pull the module out of the slot. Place your other hand under the module to support the weight of the

module. Do not touch the module circuitry.

Place the module on antistatic foam, or immediately reinstall it in another slot.

Step 8

If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain

Step 9

proper airflow through the chassis.

OL-26784-02

Cisco SCE8000 10GBE Installation and Configuration Guide

Removing a Module

9-21