Cisco SCE8000 Removal And Replacement Procedures page 14

Hide thumbs Also See for SCE8000:

Installing the Fan Assembly

Hold the fan assembly with the fans facing to the right and the FAN STATUS LED at the bottom. (See

Step 1

Figure

Place the fan assembly into the front chassis cavity so that it rests on the chassis, and then lift the fan

Step 2

assembly up slightly, aligning the top and bottom chassis guides.

Step 3

Push the fan assembly into the chassis until the power connector seats in the backplane and the captive

installation screws make contact with the chassis.

Step 4

Tighten the captive installation screws.

Step 5

Verify that fans are operational:

•

Cisco SCE8000 10GBE Installation and Configuration Guide

9-14

9-7.)

Listen for the fans; you should immediately hear them operating. If you do not hear them, ensure

that the fan assembly is inserted completely in the chassis and the faceplate is flush with the switch

back panel.

Verify that the FAN STATUS LED is green. If the LED is red, one or more fans is faulty.

Chapter 9 Removal and Replacement Procedures

OL-26784-02