Siemens SIMATIC NET TeleControl S7-1200 CP 1243-1 Operating Instructions Manual page 64

Configuration
4.8 Security
Telecontrol server under "Partner stations" of the CP
You configure the following information here:
● Address of the telecontrol server
IP address or name of the telecontrol server that can be resolved by DNS.
● Port
Port number of the telecontrol server
Users and roles in the global security settings
1. Open the following page in the project tree:
Global security settings > User management
2. Role
Open the "Roles" tab
The two tables "Roles" and "Rights of the role" become visible.
If necessary open the "Roles view" if this is hidden by the "Rights of the role" table.
In the "Roles" table (at the top) create a new user-defined role for TeleService.
3. In the "User" tab create a user that will later be allowed to execute the TeleService
functions for the CP.
Configure the following parameters:
– User name
– Authentication method
– Password
– Maximum time of the session
4. Click on the "Roles" tab.
5. Select the CP in the lower list "Rights of the role" under the "Module rights" group.
64
Assign the name of the user that will have TeleService rights.
You require the user name at the start of a TeleService session.
Select the authentication method "Password" for this user.
Assign the password.
You require the password at the start of a TeleService session.
Note:
You specify the password properties of the security functions in the "Password
policies" tab.
You enter the password on the engineering station when starting a TeleService
session.
The time that can be configured here is only required for access to SCALANCE S
modules. If the user is set up only for TeleService sessions, you can leave the default
value unchanged.
Operating Instructions, 12/2016, C79000-G8976-C365-02
CP 1243-1