Snmp; Partner Stations; Partner Stations > Telecontrol Server - Siemens SIMATIC NET TeleControl S7-1200 CP 1243-1 Operating Instructions Manual

Configuration

4.6 SNMP

4.6 SNMP
SNMP
The CP supports the following SNMP versions:
● SNMPv1
Available with security functions disabled.
Note that with this read and write access to the module is possible. In this case, other
settings are not possible.
The configuration of the community strings is only possible if the security functions are
enabled.
The CP uses the following community strings to authenticate access to its SNMP agent
via SNMPv1:
*) Note the use of lowercase letters!
● SNMPv3
Available only when security functions are enabled
For information on the configuring SNMPv3, refer to the section SNMP (Page 54).
Configuration
● "Enable SNMP"
If the option is enabled, communication via SNMPv1 is enabled on the CP.
If the option is disabled, queries from SNMP clients are not replied to by the CP either via
SNMPv1 or via SNMPv3.
4.7

Partner stations

The parameter group is only displayed when telecontrol communication is enabled.
4.7.1 Partner stations > Telecontrol server
Partner stations > "Telecontrol server"
● Partner number
The partner number for the telecontrol server is assigned automatically by the system if
telecontrol communication is enabled.
● Station address
The station address of the telecontrol server is assigned automatically by the system if
telecontrol communication is enabled.
42
Access to the SNMP agent in the CP
Read access
Read and write access
Community string for authentication in SNMPv1
*)
public
private
Operating Instructions, 12/2016, C79000-G8976-C365-02
CP 1243-1