DIAG
-
LINK
(red / green)
(green)
Loading firmware
flashing
green
flashing red
2.3
Electrical connectors
2.3.1
Power supply
Power supply
The CM is supplied with power from the backplane bus. It does not require a separate power
supply.
2.3.2
Ethernet interface X1P1
Ethernet interface
The Ethernet connector is located behind the lower hinged cover of the module. The
interface is an RJ-45 jack according to IEEE 802.3.
The pin assignment and other data relating to the Ethernet interface can be found in the
section Technical data (Page 101).
CP 1243-1
Operating Instructions, 12/2016, C79000-G8976-C365-02
CONNECT
VPN
(green)
(green)
SERVICE
Meaning
(green)
(if more than one point listed: alternative
meaning)
Loading firmware. The DIAG LED flashes
alternating red and green.
Firmware was successfully loaded.
Error loading firmware
LEDs and connectors
2.3 Electrical connectors
25