Multi-Bed Tv Codes; Reset; Easy Standard Tv Setup (No Multi-Bed); Testing The Remote - Clean Remote CR3BCB-H Instructions

CLEAN REMOTE FOR MULTI-BED TV INSTRUCTIONS
RESET: To reset remote back to original manufacturer settings, or reset the
remote to operate a standard TV:
the same time until the red LED light blinks quickly 3 times, then release both buttons. Then
follow the Easy Setup instructions below.
1. Turn on the TV and then stand back about 5 feet from TV and P
the front panel of the TV. It will not be necessary to point the remote at that exact area once the remote is
set-up.
2. Press and firmly Hold down the Setup button, do not release. The LED will blink once and then
after 7 seconds it will start code search. The LED will continue to blink every 2 seconds. Once your
TV shuts off immediately remove your finger from the Setup button; the code automatically locks
in.
3.

Testing the remote:

For TV Only: Test Power, Volume and Channel Functions, if all work correctly setup is
complete. If not, you may not have an exact code match. Start again at step #1. The code search
will continue where it left off.
Important Note: If you think you missed the code or you intend to use the remote on a different
brand TV: See RESET instructions above.
FOR HEALTHCARE TVs WITH THIS FUNCTION ONLY
CR3BCB-H

MULTI-BED TV CODES

Press hold both the Setup and the CC button down at

EASY STANDARD TV SETUP (No Multi-Bed)

oint the remote at the CENTER of