Clean Remote CR2M Series Instructions

Works over 250 brands of commercial and retail TV's and most Pay-Per-View systems
No codes needed for TVs NOT connected to Pay-Per-View Movie systems. Simple ONE TOUCH set-up
CLEAN REMOTE® works for TV only (will not work TV/DVD, TV/VCR or TV/DVD/VCR combination units)
Hidden Battery compartment and attached door to help prevent batteries from being taken
IMPORTANT--- PAY-PER-VIEW MOVIE SYSTEMS DO REQUIRE CODE ENTRY;
SEE BACK PAGE
batteries
Battery Installation:
1. Open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1)
and then lift lid upward from the back (photo A, step 2)
2. When placing AAA batteries in the compartment note the + and - symbols on the metal hinge
should make contact with the corresponding + and - end of each battery (photo B).
3. Closing cover: With keypad facing away from you gently close cover by pressing downward
(photo C, step 1) and sliding it toward the front (keypad) until it is aligned. (photo C, step 2)
4. Test remote by pressing the power button; the LED should light indicating that the batteries are in
correctly. If the LED doesn't light, then the batteries are either in wrong or the batteries are bad.
Step 2
Photo A
Open with keypad facing you
For all TV's NOT connected to Pay-Per-View Movie systems
1 . For TV's connected to pay- per - view movie systems turn over page for Instructions.
2. For TV's not connected to pay- per view- movie systems. Turn on the TV and then stand back
about 5 feet from TV and point the remote at
necessary to point the remote at that exact area once the remote is set-up.
3. Press and firmly hold down the Setup button, do not release. The LED will blink once and then after 7
seconds it will initiate code search. The LED will continue to blink every 2 seconds. Once your TV shuts off
immediately remove your finger from the Setup button; the code automatically locks in.
4. Test the remote. If basic functions work, you are done. Menu functions will only work with Pay Per View
Systems. Not all buttons will work because this is universal remote. If the main functions are not working
properly, you may not have an exact code match. Start again at step #1. The code search will continue where
.
it left off
Important Note: If you think you missed the code or are testing remote on different
brand TV's:
Reset the remote back to the beginning of the code search; first press and hold the Setup button for 3
seconds and then while still pressing the Setup button down, press and hold the CC button down at the same time until
the red LED light blinks quickly 3 times. You have now reset the code list back to the beginning. Go back to step 1.
INSTRUCTIONS FOR CR2M * CLEAN REMOTE®
Step 1
NO CODE ENTRY/ONE STEP PROGRAMMING
+ -
Photo B
Close with keypad facing away from you
the CENTER of the front panel of the TV. It will not be
After Installing 2 AAA
Step 1
press down
Step 2
Slide in
to close
Photo C
1