Clean Remote CR3BCB-H Instructions

CLEAN REMOTE FOR MULTI-BED TV INSTRUCTIONS

Battery Installation:

1. To open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1)
and then lift lid upward from the back (photo A, step 2)
2. When placing two AAA batteries
should make contact with the corresponding + and - end of each battery (photo B).
3. Closing cover: With keypad facing away from you gently close cover by pressing downward
(photo C, step 1) and sliding it toward the front (keypad) until it is aligned. (photo C, step 2)
4. Test remote by pressing the power button; the LED should light, indicating that the batteries are in
correctly. If the LED doesn't light, then the batteries are either in wrong or the batteries are bad.
Photo A
Open with keypad facing you
Before proceeding, please insure that your TV has the Multi (bed)-Code feature and the TV has been set
to the appropriate Multi (bed)-Code setting. You will need to refer to your TV's manual for TV Multi (bed)-
Code setup instructions.
1) Press and Hold the SETUP button on the remote for approximately two seconds then also Press and
Hold the ENTER button. Once a solid red light appears on the remote release both buttons.
2) Enter the corresponding 3 digit Multi-bed code from the list below.
Test the remote to insure proper operation; If everything is working you are done, if not please insure your TV
is also set to the correct Multi-Bed code and repeat Step 2 above.
FOR HEALTHCARE TVs WITH THIS FUNCTION ONLY
CR3BCB-H
in the compartment note the + and - symbols on the metal hinge
Photo B
Close with keypad facing away from you

IMPORTANT

Optional screw for
the battery
compartment is in
bag with remote
Photo C