Download Print this page

Advertisement

Quick Links

Battery Installation:
1. To open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1)
and then lift lid upward from the back (photo A, step 2)
2. When placing
two AAA batteries
should make contact with the corresponding + and - end of each battery (photo B).
3. Closing cover: With keypad facing away from you gently close cover by pressing downward
(photo C, step 1) and sliding it toward the front (keypad) until it is aligned. (photo C, step 2)
4. Test remote by pressing the power button; the LED should light, indicating that the batteries are in
correctly. If the LED doesn't light, then the batteries are either in wrong or the batteries are bad.
Photo A
Open with keypad facing you
1.
Turn ON the TV and then stand back about 5 feet from TV and point the remote at the CENTER
of the front panel of the TV
remote is set-up.
Press and firmly Hold down the SETUP button, do not release. The LED will blink once and then
2.
after 7 seconds it will start code search. The LED will continue to blink every 2 seconds. Once your
TV shuts OFF immediately remove your finger from the SETUP button; the code automatically
locks in.
3.
Testing the remote:
For TV Only: Test Power, Volume and Channel Functions, if all work correctly setup is
complete. If not, you may not have an exact code match. Start again at step #1. The code
search will continue where it left off.
For TV Plus Cable Box: Only test Power and Volume function, DO NOT CHANGE
CHANNELS. If these functions operate correctly please turn page over and see Page 2.
Important Note: If you think you missed the code or you intend to use the remote on a
different brand TV:
Copyright© 2017, Starlight Electronics LLC, Command In Hand Inc.
INSTRUCTIONS FOR CR1R AND CR3BCB
in the compartment note the + and - symbols on the metal hinge
Photo B
EASY TV SETUP
It will not be necessary to point the remote at that exact area once the
.
See trouble shooting guide on page 2.
Photo C
Close with keypad facing away from you
PAGE 1
Optional screw for
the battery
compartment is in
bag with remote
rev.04-11-2019

Advertisement

loading

Summary of Contents for Clean Remote CR1R

  • Page 1 INSTRUCTIONS FOR CR1R AND CR3BCB Battery Installation: 1. To open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1) and then lift lid upward from the back (photo A, step 2) 2. When placing...
  • Page 2 Hint: If your Cable Provider is not listed, please search by the manufacturer of your cable box. Note: If your cable box has a power button, use the CBL button on Clean Remote to power it on or off. Other...

This manual is also suitable for:

Cr3bcb