Setting Hard Disk Boot Priority - Belkin F5U198ea User Manual

Installing Driver in a "Fresh" Installation of Windows
5. Insert the F5U198 driver diskette into your floppy drive and press "Enter".
6. Press "Enter" to select the "Silicon Image SiI 3112 SATARaid Controller".
7. After the driver has been installed, press "Enter" and continue the Windows
installation procedure as normal.
8. During the operating system installation, Windows may ask you for the drivers for
the SATA card again during the "Driver Installation" part of the install. Please be
prepared with the floppy disk that was supplied with the card.

Setting Hard Disk Boot Priority

If you have an IDE and serial ATA hard drive installed in your system at the same time,
it is necessary to select one of the drives as the default boot drive. To set the boot
drive priority, you must access your computer's BIOS Setup Utility. Select "SCSI" to
boot from SATA hard disk, or select "HDD" to boot from IDE hard disk.
8
22ea_F5U198ea_Man.indd 8 29/6/05 9:26:37