Advertisement
Fig. 3: Put the egg tray on the mesh plate, and put the egg tray grille according to size of egg for in-
cubation, the width of each space shall be 5-10mm bigger than the diameter of egg, so that it's good
for turning of egg.
Fig. 4: pay attention that there's an egg turning rod in the transparent case at
the upper part of device. The rod must insert into the channel of egg tray for
the egg turning. The egg turning motor runs as long as the device is powered
on. lt runs one cycle every four hours so that it's very slow. The egg is turned
once about every 4 hours.
Fig. 5: the upper cover is put together with the base, please make sure the
cover is completely closed. The egg turning rod shall insert into the channel
of movable egg tray. The device can begin to work after powered on.
© by WilTec Wildanger Technik GmbH
Seite 5
http://www.wiltec.info
Advertisement
