Agilent Technologies M1205A V26 Service Manual page 210

$JLOHQW 0$ 99 6HULHV 6HUYLFH *XLGH

Connect all cables to the System Board as shown.
Install the Front Housing Assembly.
5HSODFLQJ WKH 6\VWHP %RDUG

Insert the System Board into the Rear Housing.

Replace the 5 screws securing the System Board to the Rear Housing.

If the System Board was replaced, reprogram the Flash Memory. Refer to "Upgrade and
Cloning Instructions" on page 2-31.

Insert the Service Port Cover into the Rear Housing.
 5HSDLULQJ WKH $JLOHQW 0RGHO 9