Rigging procedures
6. Open the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a) Remove the front top R-BLP from its storage hole, rotate the front arm up, slide it down, and lock it in place by
re-inserting the R-BLP into its link hole.
A link hole is indicated by a yellow circle.
The front top storage and link holes are the same.
b) Remove the rear top R-BLP from its storage hole, slide the angle arm so as to align the cursor with the chosen
angle label, and lock it in place by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or
1°/3°/5°/7.5°/10°).
Refer to
Array site angle setting
site angle.
104
(p.198) to obtain the angle value corresponding to the chosen array
Kara owner's manual (EN) version 1.0