Configuration Options In Heli Jive Card Mode; Progcard I/Ii, Heli Jive Card; System Settings; Select Language - KONTRONIK PROGDISK Manual

Reversion of Rotation
Allows changing the rotation direction of the
motor without changing the cables.
Hold
At activated Hold the current ooperation status
will be held constant for 0.3 seconds after
loosing the receiver signal.
Load default values
Restoration of PROGCARD II default values.
6.2.2.3 Configuration options in HELI JIVE
CARD mode
RPM Control
Switches the integrated RPM control (governor)
on or off.
Spool up time
Adjustable time until which the ESC has to reach
the intended RPM value. Adjustable between 6-
25 seconds.
Transition point
Definintion of percentage value at which the
ESC switches from gas mode to governor. Also,
the transition point defines the value for
continuous governor
Adjustabel between 40-70%.
Under voltage cut-off
Adjust the voltage value per cell at which the
ESC slows the motor down within 30 seconds.
Adjustable between 2.7V – 3.2V).
Timing/RPM
Allows definition of different timings for motors.
AUTO is recommended
motors. Adjustable from -5° - +10°.
Autorotation
Switches Autorotation (Bail-out) function on or
off.
Motor-Off-Position
For programming throttle ways connect a ready-
to-use receiver
corresponding sender has to be switched on.
The motor-off-position of the throttle is confirmed
by enter.
Autorotation-On-Position
Autorotation (Bail-out) bypasses soft spool up of
the motor. A switch defines the position at which
18
control (mode
for KONTRONIK
to the PROGDISC.
autorotation should start. This position should be
defined between 10-15%. The Autorotation
switch of the sender needs to be programmed
with 10-15%. Please refer to the manual of your
HELI JIVE how to use Autorotation.
Full-gas-Position
For programming throttle ways connect a ready-
to-use
corresponding sender has to be switched on.
The full-gas-position of the throttle is confirmed
by enter.

6.2.3 PROGCARD I/II, HELI JIVE CARD

This menu item describes the procedure for
switching between different card modes. The ESC
needs to be disconnected shortly from the battery
and the PROGDISC. After connecting and starting
again you can proceed with programming the
respective mode.

6.2.4 System Settings

6.2.4.1 Select Language

By entering Select Language the menu language of
the PROGDISC can be chosen and set.
6).

6.2.4.2 Set Neutral Point

The option Set Neutral Point allows the individual
setting of a neutral horizon point. Default value is
The
0°, i.e. the menu bar does not react, if the
PROGDISC lays or is held on straight plane.
Changing the neutral point makes sense, if for
example external influences make reading the
display hard. If you choose to set a new neutral
point you are asked to bring the PROGDSIC into
receiver to the PROGDISC. The