Installation - Bauknecht GTEA 2500 Instructions For Use Manual

Installation

• Unpack the appliance and
ensure that the various
elements (plastic bags,
polystyrene pieces, etc.) are
well out of the reach of
children.
• Remove the 4 protection
pieces inserted between
lid and appliance (A).
• Important: two of the four
protection pieces (A) used
to protect the lid during
transport must be placed in
the seats provided on the
plastic supports for the
condenser, located at the
rear of the product (E).
This is necessary in order to
ensure the correct distance of
the appliance from the wall.
• Remove the packaging
from the bottom (B) of the
freezer.
• The lid will not open while
the appliance is working
to reach the correct
temperature (for approx.
1 hour).
• Ensure the defrost water
drainage plug is correctly
positioned (C).
• Ensure the lid seal is not
damaged or deformed: to
right any deformation,
warm the seal with a hair
dryer.
• Before connecting the
appliance to the mains
supply, ensure that the
voltage corresponds to that
given on the data plate (D).
• After the freezer has been
installed, check that it is not
resting on the mains cable.
• Install the appliance in a dry,
well-ventilated place. Avoid
installation near a source of
heat or in direct sunlight.
• For optimal appliance
operation and in order to
avoid damage when the
lid is opened, leave a
space of at least 7cm
from the rear wall and
7cm at the sides.
• Fit the accessories.
Electrical connection
• Electrical connections
must be made in
accordance with local
regulations.
• Data regarding voltage and
absorbed power are given
on the rating plate on the
rear of the appliance (D).
• Regulations require that
the appliance is earthed.
The manufacturer declines
all liability for injury to
persons or animals and for
damage to property
resulting from failure to
observe the above
procedures and
reminders.
• If the plug and socket are
not of the same type, have
the socket replaced by a
qualified electrician.
• Do not use extension leads
or adaptors.
Disconnecting the
appliance
• Electrical disconnection
must be possible either by
unplugging the appliance or
by means of a double-pole
switch located upline from
the socket.
19