For Bowl-Lift Mixer; Assembling The Ice Cream Maker Attachment - KitchenAid KICA Attachment Instructions

Assembling the Ice Cream Maker Attachment

for Bowl-Lift Mixer*

To Assemble Freeze Bowl and Dasher:
NOTE: Use the Freeze Bowl immediately
upon removal from the freezer, as it
begins to thaw once removed.
IMPORTANT: Do not pour ice cream
batter into the Freeze Bowl until all parts
are assembled and the mixer is running.
1. Be sure the speed-control is OFF,
mixer is unplugged, bowl-lift
handle is in the down position,
and the mixing bowl is removed.
2. Fit the Freeze Bowl into place over
the Locating Pins.
LOCATING
PIN
3. Press down on the back of the
Freeze Bowl until the bowl pin
snaps into the spring latch.
NOTE: The Freeze Bowl is designed
to fit all bowl-lift mixers. If the
bowl pin at the back of the bowl is
too short or too long to snap into
the spring latch, remove and rotate
the bowl so the opposite bowl pin
faces the spring latch. Repeat steps
2 and 3.
Pin too
short
Correct
pin fit
4. Place the Dasher inside the Freeze
Bowl.
NOTE: The Adapter Ring is not used for
Bowl-Lift models.
* For Tilt-Head Mixer, see page 6 and 7.
8
Assembling the Ice Cream Maker Attachment
for Bowl-Lift Mixer*
To Attach Drive Assembly:
1. Be sure the speed-control is still
OFF and the mixer is unplugged.
2. Make sure the bowl-lift handle is still
in the down position, and the Freeze
Bowl and Dasher are in place.
3. Determine your mixer model by
checking for a spring on the
Beater Shaft, then position the
Drive Assembly as illustrated for
proper placement.
Step
No Step
No Spring
Spring
4. Slip the Drive Assembly onto the
Motor Head and press upward
until it is securely in place.
MOTOR
HEAD
BEATER
SHAFT
* For Tilt-Head Mixer, see page 6 and 7.
5. Raise the bowl to engage the
Dasher with the Drive Assembly
before mixing.
6. Plug the mixer into a grounded
3-prong outlet.
9