Table of Contents
Advertisement
The L60+ welder is designed for sensor manufacturers to
produce commercial grade thermocouple junctions, and by
users of large numbers of exposed junction thermocouples
such as test and development laboratories where
multipoint temperature sensing of test pieces is required.
No special skills are required and most people will be
capable of producing quality work with minimal practice. A
satisfactory thermocouple junction is produced without
using argon, but where argon is available a momentary
purge is automatically triggered immediately prior to the
weld to give optimum weld integrity.
Safety Note
1. Always protect the eyes with a suitable filter during
welding – never view the weld discharge with the naked
eye.
2. Avoid touching the rear of the welder during operation
as the power switch heat sink may run hot. This is a
normal operating condition.
1. Do not allow the hand to directly contact the welding
electrode during operation.
Operating Instructions
- 2 -
Advertisement
Table of Contents
