Table of Contents
Advertisement
above steps to pre-set the incline level from the second segment to the thirty segment.
After pre-setting all the incline level and then press the START button to start exercise, the
pre-set target training time starts counting down from pre-set target training time to 0
backward. Running speed and incline level will change according to your own user pre-set
program profile automatically. During training, you may press SPEED UP or DOWN
button to increase or decrease the running speed. You may also press INCLINE UP or
DOWN button to increase or decrease the incline level. When the pre-set target time
counts down to 0, the computer will begin beeping to remind you and the running belt will
stop automatically.
NOTE: P10 program profile will be saved in the memory of the computer after setup
for future use.
CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplugg(ed) the treadmill
before cleaning or performing routine maintenance.
Problem
CLEANING
problém
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not get excessive moisture on the display panel as this might cause
an electrical hazard or electronics to fail.
Treadmill will not
Please keep the treadmill, especially, the console, out of direct sunlight to prevent screen
start.
damage.
STORAGE
Store the treadmill in a clean and dry environment. Ensure the master power switch is off
and is in the off position and the power plug is un-plugged from the electrical wall outlet.
Belt slips.
Belt hesitates
When stepped
on.
Belt is off
Centered.
Potential Causes
Potencielní
chyba
Not plugged in.
Safety tether key not
connected.
House circuit breaker tripped.
Treadmill circuit breaker
tripped.
,
Belt not tight enough.
Not enough lubrication
applied onto the running
deck.
Belt is too tight.
Running belt tension not
even across the rear roller.
Corrections
řešení
Put the power plug into the electrical
wall outlet.
Install the safety tether key.
Reset or have an electrician replace
the breaker in home.
Wait five minutes and then press
the switch back in.
Adjust belt tension.
Apply silicone lubricant.
Adjust belt tension.
Center the belt.
Advertisement
Table of Contents
