Assembly Instructions; Base Frame 1 - Spartan 1272 Owner's Manual

ASSEMBLY INSTRUCTIONS

Tool:
Allen Wrench
Step 1
Slide the Right Base Cover (30) up onto Right Handlebar Support (05). Insert the Sensor
Wire I (42) through into the bottom hole of Right Handlebar Support (05) and pull it out
from the top hole of Right Handlebar Support (05). Then install the Right Handlebar
Support (05) to the Base Frame (01) by inserting the Right Handlebar Support (05) onto
the Base Frame (01), using five M8x15 Bolts (79) and five 8mm Clock Washers (81).
Tighten bolts with the Allen Wrench Provided. Slide the Right Base Cover (30) down onto
the Base Frame (01).
Slide the Left Base Cover (29) up onto Left Handlebar Support (04). Then install the Left
Handlebar Support (04) to the Base Frame (01) by inserting the Left Handlebar Support
(04) onto the Base Frame (01), using five M8x15 Bolts (79) and five 8mm Clock Washers
(81). Tighten bolts with the Allen Wrench Provided. Slide the Left Base Cover (29) down
onto the Base Frame (01).
NOTE: Do not fully tighten hardware in step 1 until step 2 is completed.
Hardware: