Left Handlebar Support 1 - Spartan 1272 Owner's Manual

Step
Connect the Sensor Wire I (42) from the Right Handlebar Support (05) to the Sensor Wire
II (43) from the Computer Bracket (06). Then install the Computer Bracket (06) to the
Right and Left Handlebar Supports (05, 04) by inserting the Computer Bracket (06) into the
Right and Left Handlebar Supports (05, 04), using six M8x15 Bolts (79) and six 8mm Clock
Washers (81). Tighten bolts with the Allen Wrench Provided.
Place the Safety Tether Key (51) onto the Computer (50).
NOTE: PLEASE FULLY TIGHTEN ALL HARDWARE INSTALLED IN STEP 1 AND
STEP 2 WITH THE ALLEN WRENCH PROVIDED.
IMPORTANT: While sliding the computer bracket into the right and left handlebar
supports, make sure the wires are installed inside the right handlebar supports and pay
attention not to pinch the wires.
10 Bolts (M8x15)
šroub
10 Clock Washers (8mm)
Ozuběná podložka
Tool:
Allen Wrench
Univerzálny
šroubovák
2