Parts Of The Remote Controller - DAEWOO ELECTRONICS DLM-42U1 Instruction Manual

Parts of the remote
This remote controller is universal; thus, it may be convertible for TV, Video, CTV, etc.
1
4
3
7
8
11
13
15
P.STILL
17
18
21
23
24
25
26
27
All manuals and user guides at all-guides.com
controller
1. RECALL : The present modes(TV, Video, Component, PC,
HDMI, MMP) and Signal.
2.
2
3. TV : When you press this button in the AV or Multimedia
5
6
mode, the TV will go to TV mode.
4. AV/COMP/MMP : Each time you press this button, the
TV will cycle through :
AV1 => AV2(S-Video) => COMPONENT => MMP(Option)
=> AV1
5. HDMI/PC : Each time you press this button, the TV will
9 cycle through :
HDMI1 => HDMI2 => PC => HDMI1
10
6. PREV PR : Using this button, you can select a previous
12
channel.
7. NUMBER : Press the numbers on this board, you can
select PR directly in TV mode.
14
Note. : When the current state is Stand-By mode, you can
turn on the TV using the digit key.
8. LOCK : Prevent the use of the TV set without the remote control.
16
9.
Dual1, Dual2, NiCAM STEREO. It works only in TV mode.
20
19
10. EDIT : Programme Edit Display Button, See the page 30.
11. GUIDE : Go to previous menu in the MMP mode(Option).
12. OK : Confirm to change a part of the menu.
22
13. MENU : Menu display button.
14. CURSOR : Select on item in the menu left, right, up and down.
15. SUB MENU : MMP Menu display button in MMP
mode(Option).
16. SUB TITLE : Select the subtitle language in MMP
29
mode(Option).
28
17. PIP/POP(Red) : Using this button, Select either PIP/POP
On or Off.
18. P.STILL(Green) : Using this button, you can freeze the sub
screen in POP mode.
19. P.SWAP(Yellow) : Using this button, you can swap the
main screen for sub screen.
20. P.INPUT(Blue) : Sub Screen input mode change as
follows PIP table mode or POP table mode.
(POWER) : TV on/off button in Stand-By mode.
: You can select sound mode in Mono, Stereo,
22