Connect Wiring - Broan QTR070C Manual

INSTALL HOUSING & DUCT
1. Bend
housing
tabs.
Use a pliers to
bend housing
0
TABS out to 90 .
2. Mount
housing to
(use for mounting to I-Joist)
joist.
Hold housing in
place so that the
housing tabs con-
tact the bottom
of the joist. The
housing mounts
with four (4)
screws or nails.
Screw or nail
housing to joist through lowest holes in each
mounting fl ange, then through highest holes.
NOTE: Mounting to I-JOIST (shown) requires use of
SPACERS (included) between the highest hole of each
mounting fl ange and the I-joist.
3. Attach
damper/duct
connector.
Snap damper/
duct connector
onto housing.
Make sure con-
nector is fl ush with
top of housing and
damper fl ap falls
closed.
4. Install 4"
round
ductwork.
Connect 4-inch
round ductwork
to damper/duct
connector. Run
ductwork to a
roof cap or wall
cap. Tape all
ductwork
connections to
make them secure and air tight.
TABS
SPACER
I-JOIST

CONNECT WIRING

5. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.
MODEL QTR070C
Page 3