Connect Wiring; Service Parts - Broan ULTRA SILENT QTXE080 Manual

CONNECT WIRING

4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.

SERVICE PARTS

Key No. Part No.
1 97016466 Housing
2 97016450 Duct Connector-6"
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97018010 Wire Panel/Harness Assembly
6 97017782 Blower Assembly (QTXE050)
97020047 Blower Assembly (QTXE080)
97020048 Blower Assembly (QTXE110)
7 99140199 Grille Spring (2 req'd)
8 97017621 Grille Assembly (includes key no. 7)
9 97018014 Spacer (2 supplied)
10 QTHB1 Hanger Bar Kit
11 99420665 Thumbscrew, #8-18 x .375
Order service parts by "Part No." - not by "Key No."
SERVICE NOTE To remove Blower Assembly: Unplug motor.
Remove thumbscrew (11) from motor plate flange. Find the
single TAB on the motor plate (located next to the receptacle).
Push up near motor plate tab while pushing out on side of hous-
ing. Or insert a straight-blade screwdriver into slot in housing
(next to tab) and twist screwdriver.
Description
MODELS QTXE050 • QTXE080 • QTXE110
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against
ceiling.
Page 4
Replacement parts
can be ordered on our
website. Please visit
us at www.broan.com
99045491A