Arrow T50AC Series Manual page 4

SPECIFIC WARNINGS & SAFETY RULES
TOOL SAFETY WARNINGS
Always assume that the tool contains fasteners.
Careless handling of the tool can result in unexpected
firing of fasteners and personal injury.
Do not point the tool towards yourself or
anyone nearby. Unexpected triggering will discharge
the fastener, and can cause an injury.
Do not actuate the tool unless the tool is placed
firmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may be deflected
away from your target.
Disconnect the tool from the power source
when the fastener jams in the tool.
While removing a jammed fastener, the tool may
be accidentally activated if it is plugged in.
Use caution while removing a jammed fastener.
Point the tool away from self and others.
The mechanism may be under compression and the
fastener may be forcefully discharged while attempting
to free a jammed condition.
Do not use this tool for fastening electrical
cables. It is not designed for electric cable installation
and may damage the insulation of electric cables, thereby
causing electric shock or fire hazards.
6
SPECIFIC SAFETY RULES
1. Hold tool by insulated gripping surfaces when
performing an operation where the tool may
contact hidden wiring or its own cord.
Contact with a "live" wire will also make exposed metal
parts of the tool "live" and can shock the operator.
2. Know your power tool. Read operator's manual
carefully. Learn its applications and limitations, as well
as the specific potential hazards related to this tool.
Following this rule may reduce the risk of electric shock,
fire, or serious injury.
3. Always wear safety glasses with side shields.
Everyday glasses have only impact resistant lenses.
They are NOT safety glasses. Following this rule may
reduce the risk of eye injury.
4. Protect your hearing. Wear hearing protection during
extended periods of operation. Following this rule may
reduce the risk of serious personal injury.
5. Protect your lungs. Wear a face or dust mask if
the operation is dusty. Following this rule may reduce
the risk of serious personal injury.
6. Do not attempt to alter the tool. Your T50AC
has a tested cycling time. It is designed to perform
adequately at this rate. Any unauthorized alteration
and/or use could result in a hazardous condition causing
possible serious personal injury. Unauthorized parts
and/or tool modification automatically voids warranty.
7. The tool should always be supplied via
CLASS A residual current device (GFCI)
FUNCTIONAL DESCRIPTION
V ...................... Volts
A ...................... Amperes
Hz .................... Hertz
- ...................... Alternating Current
™
Moter Drive
Technology
LED
work light
DEFINITION OF SYMBOLS USED ON TOOL
& FUNCTIONAL DESCRIPTION
Obey all safety messages that follow this
symbol to avoid possible injury or death.
To avoid loss of hearing, always wear
ear protection when operating the tool.
Low staple/nail indicator light
Soft overmold grip
Contact safety
To avoid eye injury always
wear safety glasses when
operating the tool.
Class II Tool
Power cord
Trigger
On/off switch
Quick release
magazine
7