Technical Specifications; Troubleshooting - STEINEL Spot Way Sensor Connect Instructions Manual

or replacement of defective parts at our own discretion. The warranty shall not cover
damage to wear parts, damage or defects caused by improper treatment or mainte-
nance. Further consequential damage to other objects shall be excluded.
Claims under the warranty will only be accepted if the unit is sent fully assembled and
well-packed with a brief description of the fault, a receipt or invoice ( date of purchase
and dealer's stamp ) to the appropriate Service Centre.
Repair service:
If defects occur outside the warranty period or are not covered by the warranty,
ask your nearest service station for the possibility of repair.
5
3
Y E A R Y E A R
MANUFACTURER'S MANUFACTURER'S
WARRANTY WARRANTY

11. Technical specifications

Dimensions
(W × D × H) Way spot: 140 × 226 × 572 mm
(W × D × H) Garden spot: 69 × 118 × 369 mm
Cord length 2500 mm
Input voltage 220-240 V, 50/60 Hz
Output
• Stand by Approx. 0.5 W
• Operation Approx. 0.5 W + LED lamp
Lamp GU10 LED lamp (max. 9 W)
Sensor technology Passive infrared
(Way/Garden Sensor Connect spot only)
Detection zone (Way/Garden Sensor Connect spot only)
• Angle of coverage 90°
• Angle of aperture 90°
Reach Max. 10 m
(Way/Garden Sensor Connect spot only)
Time setting 5 s - 60 min
(Way/Garden Sensor Connect spot only)
Twilight setting 2-1000 lux
(Way/Garden NightAutomatic spot only)
2-2000 lux
(Way/Garden Sensor Connect spot only)
– 22 –
IP rating IP44
Protection class I
Temperature range -20 – +40°C
Bluetooth frequency 2.4 – 2.48 GHz
(Way/Garden Sensor Connect spot only)
Bluetooth transmitter power 5 dBm / 3 mW
(Way/Garden Sensor Connect spot only)

12. Troubleshooting

Malfunction Cause
LED light does not switch
■ Fuse has tripped,
ON
not switched ON,
break in wiring
■ Short circuit
■ Lamp faulty
NightAutomatic LED light
■ Twilight setting in
does not switch ON
night-time mode during
daytime operation
■ Mains switch OFF
■ Fuse has tripped
■ Detection zone not
correctly adjusted
NightAutomatic LED light
■ The twilight setting is set
does not switch OFF
to permanently ON
during night-time
operation
■ Continued movement
within the
detection zone
■ Light-level sensor is
covered (e.g. by leaves).
Sensor Connect LED light
■ Animals moving in
keeps switching ON/OFF
detection zone
Remedy
■ Activate, change fuse,
turn ON mains switch,
check wiring with
voltage tester
■ Check connections
■ Change lamp
■ Reset
■ Switch ON
■ Activate, change fuse,
check connection if
necessary
■ Readjust
■ Reset
■ Check zone and
readjust if necessary
or apply shroud
■ Remove shrouds from
light-level sensor
■ Tilt sensor higher or fit
shrouds to target
sensor;
adjust detection zone
or fit shrouds
– 23 –