• Due to the complex dynamics of falling, all falls may
not be detected. In the event of a fall not being
detected the manual button can still be used to call
for help.
• It is not recommended that you wear the fall
detector whilst in bed, as normal movement in bed
may cause the fall detector to trigger.
How it works - Automatic fall detection
• Green light and two "beeps" indicate that the fall
detector has been activated.
• The fall detector will then monitor for between 6
and 15 seconds to verify if there could have been a
fall. The green light will flash while it does this.
o If the detector has decided that there is a fall,
o If the detector has decided that it was
then a red light and four "beeps" indicates
that the fall detector is about to trigger an
alarm call (because it has detected an impact
and has not been upright for between 6 and
15 seconds).
activated by error then the green flashing
light will stop after between 6 to 15 seconds
and the unit will revert to normal operation
again.
Page 5 of 12
User Guide